Skip to content

Measurement

True RMS vs average-responding meters: when the difference matters

Average-responding meters are accurate on pure sine waves. On modern non-linear loads they can read significantly low.

OSAKA TOOL Engineering Desk · · 2 min read

What RMS means

The root-mean-square value of an AC signal is the equivalent DC value that delivers the same heating power. It is the value that matters for conductor sizing, protective device behaviour and power calculations.

How average-responding meters work

A lower-cost meter rectifies the signal, measures the average, and multiplies by 1.11, the ratio between RMS and average for a pure sine wave. On a clean sine wave this is accurate. On a distorted wave, the ratio is different and the reading is wrong.

Where distortion appears

  • Variable-frequency drives and soft starters
  • LED drivers, switch-mode power supplies and computer loads
  • UPS systems and inverters
  • Phase-angle dimmers and heater controllers

The current drawn by single-phase rectifier loads is often sharply peaked. An average-responding clamp meter can under-read that current substantially, which leads to undersized conductors or unexplained breaker trips.

Recommendation

For any electrical maintenance or installation work on modern buildings and industrial plant, specify True RMS meters and clamps. Check the crest factor specification and the bandwidth of the True RMS converter as well.

Send a specification. Receive a quotation.

Model numbers, quantities and destination country. We reply with availability, lead time and the documents your project needs.