Skip to content

Product family

Electrical Test & Measurement

Handheld and bench instruments for measuring voltage, current, resistance, continuity and insulation in low-voltage electrical systems.

Subcategories

Inside Electrical Test & Measurement

Catalogue

Sourced to your specification

Listings for this category are being prepared.

Our sourcing desk supplies electrical test & measurement to specification now. Share the model, standard or measurement range you need, and we will confirm availability, manufacturer and documentation.

We use your details only to respond to this inquiry.

Buyer guidance

How to choose electrical test & measurement

Start with the measurement category. IEC 61010-1 defines CAT II (equipment plugged into outlets), CAT III (distribution boards, fixed installations, motors) and CAT IV (the origin of the installation, such as the utility connection and meters). An instrument rated CAT III 600 V is suitable for building distribution work; service-entrance work needs CAT IV.

Choose True RMS when you measure loads with variable-speed drives, LED drivers, switch-mode power supplies or any distorted waveform. Average-responding meters can read significantly low on these signals.

Check the accessories as carefully as the instrument. Test leads, probes and clamps must carry an equal or higher CAT and voltage rating, or the whole measurement chain is limited to the weakest part.

Related reading

Technical articles

Send a specification. Receive a quotation.

Model numbers, quantities and destination country. We reply with availability, lead time and the documents your project needs.